Skip to end of metadata
Go to start of metadata

Create a new Route Group

Step 1 - Select Call Routing / Route/Hunt / Route Group menu item and click on the Add New button.

Step 2 - Add a name to the group in Route Group Name.

Step 3a - In case of Verba network-based or dial-in recording, set the Distribution Algorithm setting to Top Down.

Step 3b - In case of Verba proxy-based recording or the Announcement service, set the Distribution Algorithm setting to Circular. If the servers are in separate sites, and the load-balancing is not required, then set the Distribution Algorithm setting to Top Down.

Step 4 - Assign the previously created SIP trunk(s) to this route group at the Find Device to Add to Route Group pane. After selecting the desired SIP trunk(s), click on the Add to Route Group button.

Step 5 Click on the Save button.

Create a new route list

Step 1 - Select Call Routing / Route/Hunt / Route List menu item and click on the Add New button. If you already have one, simply select it from the list.

Step 2 - Set a Name for the list.

Step 3 - Select the appropriate Cisco Unified Communications Manager Group and click on the Save button.

Step 4 - Click on the Add Route Group button at the Route List Member Information panel.

Step 5 - Select the previously created route group at the Route Group setting, then click Save.

Step 6 - At the Route List Configuration page, click on the Save button.

Create a new route pattern

Step 1 Select Call Routing / Route/Hunt / Route Pattern menu item and click on the Add New button.

Step 2 Set the Route Pattern value.

  • In case, of network-based, dial-in recording or announcement, the Route Pattern value has to be a free directory number, not used by any other devices. Make sure it does not collide with your numbering plan.
    The routing of the entered number can be verified in the Call Routing / Route Plan Report menu.
  • In case of proxy-based recording see the instructions under Stage Three in Cisco UCM configuration example for proxy based recording
Step 3 Set the Gateway/Route List to the one created/modified in the previous step.

Step 4 Click on the Save button.

  • No labels